fix(zigbee): Enable the internal pull-up resistor for BUTTON_PIN #10491
+5
−5
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Description of Change
Configure
BUTTON_PIN
/SWITCH_PIN
as an input and enable the internal pull-up resistor.I am facing a factory reset loop using a Waveshare ESP32-H2-DEV-KIT-N4 board witout enabling pull-up.
Tests scenarios
I tested this with :
Waveshare ESP32-H2-DEV-KIT-N4 board
ESP32-C6-WROOM-1 board
Related links
Please provide links to related issue, PRs etc.